Sensor/switch actuator, 8/8gang

Combination device with 8 binary inputs and 8 switch actuators. Conventional push-buttons or auxiliary contacts can be connected to 8 channels. The information of the contact enquiry can be used for activating ABB-free@home® actuators or for recording status information. The contact polling voltage is made available by the device itself. Maximum cable length at a cable cross-section of 1.5 mm² < 100 m For switching 8 independent 230 V~ loads. Bus voltage: 24 V Inputs: 8 Polling voltage: 35 V- Outputs: 8 Normally open contact, potential free Suitable for: AC1 Rated current: 6 A, cos φ0.8 Output voltage: 230 V~ Suitable for: AC3 Rated current: 6 A, cos φ0.45 Output voltage: 230 V~ Protection class (Device): IP 20 Temperature range (Device): -5 °C to 45 °C Dimensions: (L x W x D): 90 mm x 144 mm x 64.5 mm Module width: 8 MW No additional commissioning software is required. Programming only with bus voltage applied via the web interface of the System Access Point. Additional information about commissioning and operation is contained in the system manual and the online operating manual of the current Online-Catalogue.